JUKI DLN-6390 Manuel D'utilisation page 105

Table
3
2
1
[In case of the machine without thread trimmer]
) Install ar (asm.) 1 on the bottom face of the table wth
two screws 2 suppled wth the unt at the poston as
shown in the figure.
2) Pull upward knob 3 located at the upper part of the
ar (asm.) and turn t to the rght or left to adjust the
pressure to approxmate 0.5 MPa.
After adjusting the pressure� fully push
down the knob 3 until it comes down to
its home position.
4