Installing The Hemming Binder - JUKI DLN-6390 Manuel D'utilisation

4. Installing the hemming binder
WARNING :
To protect against possible personal injury due to abrupt start of the machine� be sure to start the
following work after turning the power off and ascertaining that the motor is at rest.
1
8 to 10 mm
0.3 to 1.2 mm
2 to 3 mm
4
6
2
0.2 to 0.8 mm
4
3
6
5
Install hemmng bnder 1 on the sewng machne usng
setscrews 2 (tghtenng torque : 4 to 6 N·m).
■ Standard of installing position
• Vertcal poston : clearance between left gude secton
and throat plate : 0.3 to .2 mm
• Longtudnal poston : clearance between hemmng
bnder and presser : 0.3 to .2 mm
• Left gude : 8 to 0 mm from left end of throat plate
• Rght gude : clearance between rght gude and rght
end of presser : 0.2 to 0.8 mm
• Assemble the hemmng bnder so that t s almost
parallel to top surface of throat plate and front face of
throat plate.
1. Installing position above is the
standard installing position. Use the
sewing machine after adjusting the
installing position to the position where
you can handle the binder with ease.
2. Make sure that the sewing machine
and the hemming binder do not come
in contact with each other at the time
of open/close of the hemming binder.
■ Adjusting the position between hemming binder
and air cylinder (DLN�6390�7)
• Loosen setscrew 5 and adjust the lateral poston of
ar cylnder so that the clearance between top end 4
of the hemmng bnder and top end 3 of the ar cyln-
der s 2 to 3 mm.
• Adjust so that top end 3 of the ar cylnder s almost n
the center aganst top end 4 of the hemmng bnder.