InnoCigs EVIC PRIMO 2.0 Manuel D'utilisation page 65

INNOCIGS EVIC PRIMO 2.0 – USING THE DEVICE
Setting the Logo Mode
Press the Fire button and the "Up" button at the same time to enter the screen protection
mode. Press the "Up" button again to enter the logo mode. You can select between "On"
(logo will be displayed) and "Off" (logo will not be displayed) with the control function. Press
the Fire button to confirm your selection. Connect the device to your computer using the USB
cable to upload your personal logo. Use a monochrome image in bmp format with a maximum
of 64 x 40 pixels for your logo.
Setting the Pre-Heating Function
Press and hold the Fire and "Up" buttons while the power is on to enter the menu. Then
press the "Up" button twice to enter the PREHEAT submenu. Press the „Down" key
and then the fire key to switch between the pre - heating capacity and the duration.
Press the left or right adjustment button to change the settings. Press and hold the Fire
button to confirm your setting.
63