MEDC FB15 Manuel Technique page 5

The IECEx certificate and product label carry the IECEx equipment protection level marking
Dip A21
Where Dip signifies suitability for use in the presence of dust
Where A21 signifies suitability for use in the presence of dust in a Zone 21 area.
ATEX units
Certified to EN50014:1997, EN50281-1-1:1998 and EN50018:2000
ATEX certification No. Baseefa04ATEX0009X
For a 60W bulb:
EE xd IIC T200°C (Tamb -55°C to +70°C)
T135°C (Tamb -55°C to +55°C)
For a 100W bulb:
EE xd IIC T200°C (Tamb -55°C to +40°C)
The ATEX certificate and product label carry the ATEX group and category marking:
II 2 GD
Where:
Signifies compliance with ATEX
II Signifies suitability for use in surface industries
2 Signifies suitability for use in a zone 1 area
G Signifies suitability for use in the presence of gases
D Signifies suitability for use in the presence of dust
The ATEX certificate and product label also carry the following mark:
This signifies unit compliance to the relevant European directives, in this case 94/9/EC, along with the number
of the notified bo dy issuing the EC type examination certificate.
6. SPECIAL CONDITIONS FOR SAFE USE
1. Painting and other surface finishes, other than those applied by the manufacturer, are not permitted
2. In order to maintain the dust tight integrity of the enclosures (IP6X), the threads f cable entry devices
and stopping plugs shall be sealed in accordance with the applicable code of practice for flameproof
installation
© MEDC 2015 07/15