Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
6. ERROR CODES
M
ESSAGE ON THE SCREEN
E
RROR
MEMORY ERROR
Memory error in the electronics
NO INPUT SIGNAL
Probe error
EE COM. ERROR
Hardware error (EEPROM communication error)
MATH. OVERLOAD
Display overflow
SIGNAL IN N.D.B.
Probe or calibration error (Signal is in near dead band)
SIGNAL IN F.D.B.
Probe or calibration error (Signal is in far dead band)
VMT SIZE ERROR
Linearization error: Less than two items are in the table.
Linearization table error: monotonicity error in the input (level) side
VMT INPUT ERROR
of the table.
Linearization table error: monotonicity error in the output (volume
VMT OUTPUT ERROR
or mass) side of the table.
Linearization table error: The measured level is greater than the
VMT INPUT OV.RNG.
highest level of the table's input side.
EE CHK ERROR
Parameter checksum error.
Parameter consistency error.
INTEGRITY ERROR
(Automatically fixed internal error.)
Only WARNING
AC COM. ERROR
Hardware error
CALIBRATION ERROR
Sensor calibration error
34 / 36 mba5052i0600p_06 ♦ BKI16ATEX0012X ♦ IEC Ex BKI 12.0002♦ FM16US0068X♦ FM16CA0037X
D
ESCRIPTION
P
ROCEDURE
Contact the service!
Contact the service!
Contact the service!
Check the programming!
Contact the service!
Check the mounting specifications.
Check the content of the VMT! See: 5.3.4.6.
Check the content of the VMT! See: 5.3.4.6.
Check the content of the VMT! See: 5.3.4.6.
Check the content of the VMT! See 5.3.4.6.
Device performs extrapolation according to the last
point pairs!
Check the programming!
For regenerating the checksum, modify a Parameter
and return to Measurement mode.
If this error still remains, contact the service!
Check the programming!
Contact the service!
Contact the service!
C
ODE
1
2
3
4
5
7
12
13
14
15
16
17
18
Publicité
Table des Matières
