Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
5.1. T
SAP-300
HE
DISPLAY UNIT
5.1.1. T
SAP-300
HE
MODULE
The SAP-300 is a 64x128 dot-matrix LCD display which can be plugged into the transmitter. (Universal – usable in
other NIVELCO devices as well – provided that the system software supports SAP-300.)
Warning!
The SAP-300 module is based on LCD technology, so please make sure it is not exposed to permanent heat or
direct sunlight, in order to avoid damage of the display unit. If the instrument cannot be protected against direct
sunlight or high temperature that is beyond the standard operating temperature range of the SAP-300, please do not
leave the SAP display in the instrument.
Displaying with the SAP-300 module
Elements of the display:
1. Primary value (PV), as per BASIC SETUP / PV. MODE.
2. Mode of primary value calculation, as per BASIC SETUP / PV. MODE.
3. Type and value of the initial value for primary value calculation:
- In case of level measurement: distance
- In case of volume or mass calculation: level
Trend direction arrows. . Trend direction arrows. The empty triangle shows when the measured value is
small, the filled triangle shows large-scale change. The measured value is constant if none of the arrows
are shown.
5. Measured value in relation to measurement range (Sensor range) in a bargraph.
6. Indication of primary value simulation. In this case the display and output will show the values of the
simulation and not the measured value.
7, Indication of the Volume/Mass calculation table (Volume/Mass Table - VMT)
During active simulation the critical measurement errors will be displayed to give information to the user.
FM16CA0037X ♦ FM16US0068X ♦ IEC Ex BKI 12.0002 ♦ BKI16ATEX0012X ♦ mba5052i0600p_06 ♦ 19 / 36
2
3
6
L:2.345m
4
VOL
SIM
5
VMT
Io: 12.00mA
4
7
A
1
C
0
3
m
M
B
Publicité
Table des Matières
