Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Dialog window
The system sends messages or warnings using dialog windows. These usually can be acknowledged by
pressing the
button or the user can choose between two options (usually YES or NO) by pressing
buttons. In some cases to correct an error one of the parameters has to be changed.
Edit window
An edit window is used for modifying a numeric parameter value. The selected character can be changed using
the
/
buttons. The cursor can be moved to left, using the
movement through the digits is right to left. Changed value can be validated by pressing the
software checks if the entered value is appropriate, exiting the edit window is only possible after entering a
correct value. If the entered value is uninterpretable the software sends an error message in the bottom line (1)
of the display. The display gives the same error message, independently of the measured value and the
measurement principle.
Edit window – button combinations
In the edit window the following button combinations are available:
Recalling the parameters to the state before editing (
Recalling default parameters (
Inserting (currently) measured value to the edit window (
Only for certain parameters!
5.2.2. Menu structure
Main menu
BASIC SETUP
OUTPUT SETUP
CALCULATION
SERVICE
+
+
, pressed for 3 secs);
+
Parameter group of the basic measurement parameters
Parameter group of the output parameters
Calculations
Service functions, calibration, test and simulation
FM16CA0037X ♦ FM16US0068X ♦ IEC Ex BKI 12.0002 ♦ BKI16ATEX0012X ♦ mba5052i0600p_06 ♦ 23 / 36
button. The direction of the cursor
E
, pressed for 3 secs);
, pressed for 3 secs)
/
button. The
Publicité
Table des Matières
