Publicité
Les langues disponibles
Les langues disponibles
Connect the flat cable of the alarm board to the
base's board.
Check the correct
h
h
direction of the cable.
Fig. 03
Apply a little pressure to hook the alarm board to the
4 spacers.
Fig. 04
Reposition the upper unit onto the base following
the procedure described in Fig. 01, page 2, in reverse
order.
6.1.2 Configuring the dip-switch of the
CPU board
Before powering the device it must be configured
correctly by setting the dip-switches on the CPU board.
Unscrew the screws to remove the side of the pan &
tilt.
Fig. 05
Find the dip-switch of block DIP4 on the CPU board.
Position dip-switch 3 of block DIP4 to ON to enable
its management.
When the dip-switch rocker (SW) is on the
h
h
left it represents the value 1 (ON) while if
it is on the right it represents the value 0
(OFF).
Fig. 06
Reassemble the side.
7 Disposal of waste
materials
This symbol mark and recycle system
n
h
are applied only to EU countries and not
applied to the countries in the other area of
the world.
Your product is designed and manufactured with
high quality materials and components which can be
recycled and reused.
This symbol means that electrical and electronic
equipment, at their end-of-life, should be disposed of
separately from your household waste.
Please dispose of this equipment at your local
Community waste collection or Recycling centre.
In the European Union there are separate collection
systems for used electrical and electronic products.
3
Publicité
