Publicité
Les langues disponibles
Les langues disponibles
4 Identification
4.1 Product description and type
designation
Alarm board kit for ULISSE COMPACT.
4.2 Product markings
See the label attached to the outside of the package.
5 Preparing the product
for use
Any change that is not expressly approved
h
h
by the manufacturer will invalidate the
guarantee.
5.1 Contents and unpacking
When the product is delivered, make sure that the
package is intact and that there are no signs that it
has been dropped or scratched.
If there are obvious signs of damage, contact the
supplier immediately.
Keep the packaging in case you need to send the
product for repairs.
Check the contents to make sure they correspond
with the list of materials as below:
• Electronic board with flat cable UCAC1
• Spacers
• Instructions manual
5.2 Safely disposing of
packaging material
The packaging material can all be recycled. The
installer technician will be responsible for separating
the material for disposal, and in any case for
compliance with the legislation in force where the
device is to be used.
Bear in mind that if the material has to be returned
due to a fault, using the original packaging for its
transport is strongly recommended.
2
6 Assembling and
installing
Only specialised personnel should be
h
h
allowed to assemble and install the device.
6.1 Installation
6.1.1 Installing the alarm board
Before any technical work on the appliance,
g
h
disconnect the power supply.
Unscrew the 4 screws to gain access to the base.
Remove the upper unit from the base.
Fig. 01
Insert the spacers into the board's 4 holes.
Check the correct
h
h
direction of the spacers.
Fig. 02
Publicité
