Skil RT1322-00 Mode D'emploi page 25

WARNING
personal injury.
6. Unplug the router from the power source, place the router on worktable, and inspect the
finished cut in the workpiece.
WARNING
loss of control, causing serious personal injury.
Freehand Routing with the Fixed
Base (Fig . 20)
WARNING
Use of large cutter bits when freehand routing
could cause loss of control or create other
hazardous conditions that could result in
personal injury. If using a router table, large
bits should be used for edging only.
When used freehand, the router becomes a
flexible and versatile tool. This flexibility makes
it possible to easily rout signs, relief sculptures,
etc.
When freehand routing:
1. Draw or lay out the pattern on the workpiece.
2. Choose the appropriate bit.
3. Follow the instructions for INTERNAL ROUTING, and route the pattern in two or more
passes. Do not exceed 1/8-in. depth of cut in a single pass. This will help provide better
control, as well as serve as a guide on the next passes.
NOTICE: A core-box bit or V-groove bit is often used for routing letters and engraving objects.
Straight bits and ball mills are often used to make relief carvings. Veining bits are used to
carve small, intricate details.
NOTICE: Making a single deep cut is never advisable. Smaller-diameter bits are easily broken
by too much side thrust and torque. Larger bits will cause a rough cut and be difficult to guide
and control. For these reasons, do not exceed 1/8- in. depth of cut in a single pass.
WARNING
loss of control causing possible serious personal injury.
Removing the cutter bit from the workpiece while it is still rotating could
damage the workpiece and result in loss of control, causing serious
Always securely clamp the workpiece in place, and keep a firm grip on the
router base with both hands at all times. Failure to do so could result in
Do not use large cutter bits
for freehand routing.
Always securely clamp your workpiece in place, and keep a firm grip on
the router base with both hands at all times. Failure to do so could result in
Fig. 20
25