Toggle "On/Off" Switch
Use the toggle switch located on the top cap of
the motor housing to turn the router "ON" and
"OFF".
The left side of the toggle switch hood (as you
face it) is marked "I" for "On" and the right side
(as you face it) is marked "O" for "Off".
To turn the motor "ON", push the toggle switch
to the left side marked "I", or "On". To turn the
motor "OFF" push the toggle switch to the right
side marked "O", or "Off".
Contact the workpiece with the router and
cutter bit only after the router has reached full
speed. Turn the router motor "OFF" and allow
the cutter bit to come to a complete stop before
removing the router and cutter bit from the workpiece.
Soft-Start Feature
The soft-start feature minimizes torque twist, customary in larger router motors, by limiting the
speed at which the motor starts. This increases the motor's life.
Electronic Feedback Control
The electronic feedback control maintains a constant speed under load to provide a smooth
finish.
LED Worklights (Fig . 11)
Your router motor has 3 built-in worklights,
located around the collet/nut, to provide high
visibility of workpiece when cutting. These
lights are always "On" when the toggle switch
is in the "On" position.
Fig. 10
Fig. 11
19