Skil RT1322-00 Mode D'emploi page 21

NOTICE:
a. If the inner screws on the fixed base wear
down or become loose, tighten the inner
screws:
Pull the edge-guide lever up to strip from the
•
hex nut of the inner screw, turn the edge-
guide lever clockwise (for the right edge
guide lever) or counterclockwise (for the left
edge guide lever) then push the edge-guide
lever down (Fig.14).
Turn the lever counterclockwise (for the right
•
edge-guide lever) or clockwise (for the left
edge-guide lever) to secure the edge-guide rod.
b. If the inner screws on the plunge base wear
down or loosen, to tighten the inner screws:
Pull the edge-guide lever up to strip from the
•
hex nut of the inner screw, turn the edge-
guide lever clockwise (for the left edge guide
lever) or counterclockwise (for the right edge
guide lever) then push the edge-guide lever
down (Fig.15).
Turn the edge-guide lever counterclockwise
•
(for the left edge guide lever) or clockwise
(for the right edge guide lever) to secure the
edge-guide rod.
Electronic Variable-Speed Control
NOTICE: The chart below and all the
specifications appear on the display of the
router are only for reference for your operation.
The electronic speed control feature allows the
motor speed to be matched to the cutter size
and material hardness for an improved finish
and extended bit life.
Your motor-housing top cap has a "Variable-
Speed Selection Chart" located above the "ON/
OFF" toggle switch, to help you determine the
correct speed for the cutter bit being used.
Press "SET" to scroll through the settings of
the cutter type, cutter size, and the cutting
material.
Press "+" or "-" directly to choose the cutting speed according various materials of workpieces
after making above settings.
Fig. 14
Hex Nut of
Inner Screw
Fig. 15
Hex Nut of
Inner Screw
Fig. 16
3
Hex Nut of
Inner Screw
Hex Nut of
Inner Screw
2
2
1/4
1/2
PLASTICS
21