Publicité
Les langues disponibles
Les langues disponibles
INSTALLATION DIMENSIONS
The Gemma chimneys are adjustable and designed to meet varying ceiling
heights as indicated in (FIGURE 4). The chimneys can be adjusted for
ceilings between 7' 7" and 8' 10 3/8" depending on the distance between
the bottom of the hood and the cooktop (distance x in FIGURE 4).
upper
7 1/4" min
chimney
16 10/16
max
"
lower
21 5/16"
chimney
2
canopy
7/16"
19
x = distance from hood to cooktop
x
(varies depending on installation)
min - 24", suggested max - 30"
also consult cooktop
manufacturer's recommendation
36"
cabinet base
FIGURE 5
min & max ceiling height examples
x = 24"
x = 26"
min
min
7'
7'
7"
9"
max
max
8'
8'
4 3/8"
6 3/8"
"
1. Disconnect and move freestanding range from cabinet
opening to provide easier access to upper cabinet and rear
wall. Put a thick, protective covering over cooktop, set-in
range or countertop to protect from damage or dirt.
2. Determine and clearly mark with a pencil the center line
on the wall where the rangehood will be installed.
3. Based on your ceiling height and/or personal
x = 28"
x = 30"
preference, determine the distance you would like between
min
min
the bottom of the hood and the cooktop (SEE FIGURE 4
7'
8'
11"
1"
AND 5). The dimensions illustrate mounting the canopy
max
max
24" above the cooking surface.
8'
8'
8 3/8"
10 3/8"
NOTE: if installing the hood ductless, do not
install the (top) upper chimney bracket until
after installing the ductless kit
For shorter ceilings,
have the chimney
cover(s) cut at a sheet
4. The chimney mounts by two brackets (E in FIGURE
metal shop. For higher
1). Note the position of the brackets. The top bracket
ceiling installations, the
should be installed about 1/8" away from the ceiling. The
High Ceiling Chimney
bottom bracket must be installed at the bottom point of the
Kit includes a new 40"
upper chimney sleeve. See "Y" in FIGURE 5, and use 2
upper chimney which
screws (G in FIGURE 1) to attach each of the brackets
would replace the upper
to the wall. Use the center line on the wall as the middle
chimney that came with
point for the chimney brackets.
the hood.
5. For the most secure installation, the MOUNTING
SCREWS (D in FIGURE 1) which mount the CANOPY
SECTION (A in FIGURE 1) should be installed into wood.
Mark the wall along the horizontal line 4 9/16" in from the
center line on either side (as indicated in X - FIGURE 5)
FIGURE 4
and install the MOUNTING SCREWS into the wall leav-
ing about 1/4" gap between the wall and the head of the
screw.
Determine the proper location for each bracket and install
the brackets on the wall. MAKE SURE THAT THE
BRACKETS ARE SECURELY FASTENED TO THE
WALL.
6. Determine and make all necessary cuts in the wall for
the ductwork. Install the ductwork before the rangehood
if ducting outside.
7. Determine the proper location for the Power Supply
Cable. Use a 1 1/4" Drill Bit to make this hole. Run the
Power Supply Cable. Use caulking to seal around the hole.
DO NOT turn on the power until installation is complete.
PREPARE THE WALL
Version 07/11- Page 6
Publicité
