InnoCigs IRONFIST Manuel D'utilisateur page 55

Ironfist – Using the device
Settings in TC Mode (NI, TI, SS)
Push the up or down buttons in temperature mode to set the temperature from
100 °C to 315 °C or from 200 °F to 600 °F. In order to change the unit of temperature from
Fahrenheit (F) to Celsius (C), increase the temperature value to the maximum or minimum
level. If you change the set value even further above or below this range, the display will
automatically switch to the other unit.
In TC mode, the atomizer head resistance must be determined. To do this, select TC mode
and then press the fire button, so that "New Coil?" and "Same Coil?" appear on the display.
If it is a new head, confirm this using either the up button or the down button, if this is not the
case. Confirm by pressing the fire button.
Note: Please use the determination feature only at room temperature,
so that the appropriate base resistance can be displayed in lock mode.
If this is not the case, faulty measuring results can occur which can also
adversely affect the protective functions.
52