Troubleshooting - Home Skinovations Silk'n FaceFX Mode D'emploi

Removing the Silk'n FaceFX battery from device for
proper recycling:

Troubleshooting

This chapter summarizes the most common problems you
could encounter. If you are unable to solve the problem with the
information below, contact your local Silk'n Customer Service
Center for further support.
Problem
Silk'n FaceFX does
not work
Silk'n FaceFX
suddenly switches off
Device temperature
rises during recharge
14
PDF compression, OCR, web optimization using a watermarked evaluation copy of CVISION PDFCompressor
Undo the screw at the bottom panel of the
APPLICATOR.
Lift and remove the top panel of the
Push the three snaps and pull out the electronics card.
Cut the tow wires that connect the rechargeable
batteries pack to the
Cut the tow wires that connect the electronics card
to the lower panel of the
Possible Cause
The rechargeable
batteries are empty
The APPLICATOR is
broken
The rechargeable
batteries are empty
This is normal
APPLICATOR
.
APPLICATOR
.
APPLICATOR
Solution
Charge the APPLICATOR
Contact your local Silk'n customer Service
center
Charge the APPLICATOR
No action is required
.