Optika Italy OPTIKAM FAST3 Manuel D'utilisation page 5

alredy done this operation for the first USB port.
Generally, every time you use a peripheral device and after that you connect your Camera, then Windows needs
to recognize the Driver again.
It may happen sometimes that Windows doesn't recognize a Camera using one of your PC USB ports, while
gives no problem using another port.
To prevent any installation problem we have put on the CD all the software and drivers in specific folders with
an appropriate names.
How to test your Camera
In order to check if your Camera works correctly, it's not necessary to put it into the microscope: it's enough to
connect it into the USB port, run Vision Lite using the icon on your desktop, select the right driver and check
whether the shown image is not totally black.
Select the right drivers
It's very easy:
3 MP USB 3.0 CAMERA
With OPTIKA Vision Lite you have to tell the Software which is the Driver by selecting the microscope-shaped
icon.
With OPTIKA IS View the live image coming from your camera will automatically appear.
Getting started with OPTIKA Vision Lite, a very easy measuring and documenta-
tion software.
Run OPTIKA Vision Lite by clicking on its icon on your desktop.
Select the right Driver for capturing the image. Note that after choosing the driver and before capturing the image
you can set the brightness, saturation, gamma ecc..
Then you can capture the image.
The image is now ready for being manipulated using OPTIKA Vision Lite.
Getting started with OPTIKA IS View, a complete software for measuring, adjusting,
capturing images and video clip.
Run OPTIKA IS View by clicking on your desktop.
The live image with easy buttons for set your camera live view will automatically appear.
Page 5