Optika Italy OPTIKAM FAST3 Manuel D'utilisation page 4

Installation of camera drivers and software
Operating system requirements: Windows XP, Windows Vista ,Windows 7, Windows 8 or Windows 10. If your
PC is Windows XP: before the installation of your Camera please check if Service Pack2 is installed. If not,
please update your XP from the Microsoft web site. If your PC has a USB port less than 2.0, there may be some
problems in capturing image from the camera due to the slow transmission.
1. Please insert your CD and run:
\OPTIKA Vision Lite \ setup.exe
2. Now OPTIKA Vision Lite icon appears on your desktop.
3. Please run \ OPTIKA IS
4. Now the OPTIKA IS
5. Choose from the folder "\drivers" the model of camera you want to use and select the file "setup.exe".
6. The installer may show warnings about missing Windows certification: ignore such warnings and select
"Continue". Note : do NOT cancel the installation.
7. At the end of the installation process restart the PC if requested.
8. Plug the Camera in your PC: the camera will be identified and Windows will recognize the driver which has
just been installed from the CD.
Then ignore any message about Windows compatibility and select "Continue" .
Note : do NOT cancel the installation.
9. At the end of the identification process, disconnect your Camera and try to plug it again, in order to check if
the Driver was installed correctly (no Windows error messages should appear).
Should any error message appear on your PC, you will find a "\Troubleshooting" folder on your CD which
shows how to solve any problem which Windows could give.
Some notes
You should know that your Windows PC needs to install a Driver before capturing images from the camera: after
installing the driver from the CD, Windows needs to recognize the camera before using it.
Often a PC has some ports on the front and some on the back: the ports on the back are usually faster. We sug-
gest to use these ones.
All our cameras, even though they may have an external connection, do not need any external power supply
because it comes from the USB cable of your PC.
If you connect the camera into another USB port, Windows needs to recognize its Driver again even if it has
View
\ setup.exe
View
icon appear on your desktop.
Page 4