Specifications - Stihl BT 45 Notice D'emploi

English
Definitions
1 Wood Drill / Twist Drill
For drilling holes.
2 Chuck
For gripping and securing wood drill
or twist drill.
3 Assist Handle
Front handle for wood drill for
holding the power drill.
4 Knob
Selects operating position of
gearbox.
5 Fuel Filler Cap
For closing the fuel tank.
6 Air Filter Cover
Covers and protects the air filter.
7 Carrying Strap
Aid for transporting the power drill
by hand.
8 Throttle Trigger
Controls the speed of the engine.
9 Starting Throttle Lock
Keeps the throttle partially open
during starting.
10 Control Handle
Rear handle for holding and
operating the power drill.
11 Carburetor Adjusting Screws
For tuning the carburetor.
12 Stop Switch
Switches the engine's ignition off
and stops the engine.
24
13 Starter Grip
The grip of the pull starter, for
starting the engine.
14 Choke Lever
Eases engine starting by enriching
mixture.
15 Manual Fuel Pump
Provides additional fuel feed for a
cold start.
16 Planting Hole Auger
For drilling holes.
17 Flange
For mounting the assist handle to
the gearbox housing.
18 Assist Handle
Handle for planter auger for left
hand attached to flange at front end
of power drill.
19 Muffler with Spark Arresting Screen
Muffler reduces exhaust noises and
diverts exhaust gases away from
operator.
Spark arresting screen is designed
to reduce the risk of fire.
20 Spark Plug Boot
Connects the spark plug with the
ignition lead.
21 Drilling Spindle
For attaching the chuck or adapter
to the power drill.
22 Adapter for Planting Hole Auger
For mounting the planting hole
auger.

Specifications

EPA / CEPA
The Emission Compliance Period
referred to on the Emissions
Compliance Label indicates the number
of operating hours for which the engine
has been shown to meet Federal
emission requirements.
Category
A = 300 hours
B = 125 hours
C = 50 hours
Engine
STIHL single cylinder two-stroke engine
Displacement: 27.2 cc
Bore: 34 mm
Stroke: 30 mm
Engine power to 0.8 kW (1.1 bhp)
ISO 7293: at 7,000 rpm
Idle speed: 2,800 rpm
Cut-off speed: 9,500 rpm
Ignition System
Electronic magneto ignition
Spark plug (resistor Bosch WSR 6 F,
type): NGK BPMR 7 A
Electrode gap: 0.5 mm
BT 45