Using The Unit - Stihl BT 45 Notice D'emploi

English
Open up the clamp slightly.
N
Push the handle over the chuck until
N
it butts against the machine – the
clamp must engage the groove on
the gearbox housing.
Screw the handle into clamp
N
clockwise.
Move the handle to the required
N
position and tighten it down firmly.
8
Assist handle for planting hole auger
and ice auger
3
3
4
Loosen the two wing screws (3) on
N
the flange (4).
Make sure the polymer bushing is
N
properly seated (see arrow).
Push the flange onto the machine
N
as far as stop and line it up.
Insert the handle tube (5) in the
N
flange.
Move the handle to the required
N
position and tighten down the two
wing screws firmly.

Using the Unit

Your power drill can be used for a range
of applications, e.g. fence-building and
carpentry (kit for wood drill), in
landscaping and gardening (kit for
planting hole auger) and ice fishing (kit
for ice auger).
General
WARNING
To change the drilling tool, always shut
off the engine and set the rotary knob
to N.
Always fit the assist handle specified for
the drilling tool you intend to use. See
5
"Mounting the Handles".
WARNING
During operation, always hold the
machine firmly with both hands to
control unexpected reactive forces
caused by the drilling tool jamming in or
passing through the material.
BT 45