Deleting Numbers And Returning To Factory Programming - diagral TT385 Guide De Pose

Deleting a parameter
To delete a parameter (dialling type selection, listen-in function) and return to factory programming,
follow the operations below:
1
If you make a programming error, the dialler emits three short BEEP's and you must perform pro-
!
gramming again from the start.
Deleting a programmed number
For security reasons, it is impossible to delete a remote monitoring centre number when the dialler is
fixed to the wall.
To delete the number of a friend or member of your family, follow the operations below:
Memory n°
1 st number =
2 nd number =
3 number =
rd
10
Deleting all numbers (memories 1 to 6)
If a programming error is made, all the numbers saved (memories 1 to 3) can be deleted as well as
the identification numbers (memories 5 and 6).
For security reasons, these numbers can only be deleted in test mode, i.e. when the dialler has been
taken off the wall.
To delete all the programmed numbers, follow the operations below:
0
DELETING NUMBERS AND RETURNING
TO FACTORY PROGRAMMING
: dialling type selection
0
: listen-in function
1
Long BEEP: correct deletion
Press and hold
1
2
3
Long BEEP: correct deletion
Press and hold
10
Long BEEP: correct deletion
Press and hold
32