Preparing And Connecting Your Telephone Dialler; Preparing Your Telephone Dialler Near Its Location Point Without Fixing It In Place - diagral TT385 Guide De Pose

PREPARING AND CONNECTING YOUR TELEPHONE DIALLER

Tools required:
a flat-headed screwdriver (4 mm),
a Philips screwdriver with Ø 5 or 6 mm (n°1 or n°2)
a drill with Ø 6 mm bit.
7.1 Preparing your telephone dialler near its location point without
fixing it in place :
Lock the battery access flap using the
screwdriver provided in the bag of accessories.
7
Slide each aerial wire into the corresponding
aerial tube.
Check the wires are pulled taught inside the
aerial tubes and that none of the wires are
trapped.
Press the tubes into the vertical or horizontal
slots using a flat-headed screwdriver if
necessary.
If you use the horizontal slots, you should first
punch through the cable knock-outs located
on the front panel (opposite the slots).
7
18
Knock-outs