Briteq BT-W30FC Mk2 Mode D'emploi page 7

ENGLISH
 Use DOWN and UP buttons to change the DMX512 address.
 Once the correct address shows on the display, press the ENTER
button to save it.
To go back to the main menu without any change press the MENU button
shortly.
If you want to go back to normal running mode: press the MENU button
for about 2 seconds.
Channel Mode
 Press the MENU button until
 Press the ENTER button so the display starts blinking.
 Use DOWN and UP button to select the
Channel) or 1channel mode.
 To use the master / slave mode with dmx control, select the
mode or the mode.
 Once the mode is selected, press the ENTER button to confirm.
To go back to the main menu without any change press the MENU button
shortly.
If you want to go back to normal running mode: press the MENU button
for about 2 seconds.
Slave Mode
Used to make the slave unit work in opposite to the master or to
work in complete sync.
 Press the MENU button until
 Press the ENTER button, the display starts blinking.
 Use DOWN and UP button to select
show) mode.
 Once the mode is selected, press the ENTER button to save it.
To go back to the main menu without any change press the MENU button
shortly.
If you want to go back to normal running mode: press the MENU button
for about 2 seconds.
Show Mode
Used to choose the Show mode when used in standalone or
master/slave mode.
 Press the MENU button until "ShMd" is showing on the display.
 Press the ENTER button, the display starts blinking.
 Use DOWN and UP buttons to select one of the available shows:
 Show 1 (Sh 1): Fixture is placed on the floor. Tilt movement angle
210°.
 Show 2 (Sh 2): Fixture is fixed under ceiling. Tilt movement angle
90°.
 Show 3 (Sh 3): Fixture is placed on a podium, in front of the
audience. The spot is always projecting to the audience's
direction; i.e. in front of the stage. Pan movement angle (left to right
to left): 160°. Tilt movement angle: 90° (60° above horizon; 30°
below horizon.)
 Show 4 (Sh 4): Fixture is fixed under ceiling. The spot is mainly
projecting in front of the stage. Pan movement angle (left to right to
left):160°. Tilt movement angle: 90° (vertically, front 75°; back 15°)
 Once the right mode shows on the display, press the ENTER button to
save it.
BRITEQ
®
is shown on the display.
(16 Channel),
is shown on the display.
(normal) or
5/68
OPERATION MANUAL
(9
(2 light
BT-W30FC Mk2