Publicité
Les langues disponibles
Les langues disponibles
ENGLISH
To assure proper operation you need an optional "Mini DMX-SPLITTER" (order code: 4630) to isolate
the master/slave line from the main DMX-line, see drawing.
Connect 2 to maximum 16 units together using good quality balanced microphone cables. The first unit
in the chain will act as the master, the other units will act automatically as slaves.
Set the master to 1MSL or 4MSL channel mode (see previous chapter). Check the DMX-chart below to
see the difference between both channel modes.
For the DMX-controller the master and his slaves can now be considered as 1 virtual effect that needs a
start address so it can be controlled as any other DMX-unit in the DMX chain: see "DMX Address" in the
chapter "Main Menu" to see how you can set the DMX-start address.
Make sure that all units are connected to the mains.
Set the DMX-controller according to the DMX-chart below.
Done!
Remark: in order to work well to the rhythm of the music, make sure that the option "Sound State" on the
master is set to "On" (see previous chapter)
DMX-Chart for 1MSL and 4MSL working modes
1MSL mode
Electrical installation in DMX-mode:
The DMX-protocol is a widely used high speed signal to control intelligent light equipment. You need to
"daisy chain" your DMX controller and all the connected units with a good quality balanced cable.
Both XLR-3pin and XLR-5pin connectors are used, however XLR-3pin is more popular because these
cables are compatible with balanced audio cables.
Pin layout XLR-3pin:
(+)
Pin layout XLR-5pin:
(+) ~ Pins4+5 not used.
To prevent strange behavior of the light effects, due to interferences, you must use a 90Ω to 120Ω
BRITEQ
®
Pin1 = GND ~ Pin2 = Negative signal (-) ~ Pin3 = Positive signal
Pin1 = GND ~ Pin2 = Negative signal (-) ~ Pin3 = Positive signal
4MSL mode
9/68
OPERATION MANUAL
BT-W30FC Mk2
Publicité
