Changing The Batteries; Maintenance; Technical Data; General Declaration Of Conformity - Selve commeo Multi Send BASIS Guide De Démarrage Rapide

Changing the batteries/Maintenance/Technical data

8. Changing the batteries

Change the batteries if the
Multi Send. Once the battery capacity has completely depleted, the commeo Multi Send
switches itself off and cannot be switched on again either through movement or by pressing
a button.
Opening the battery compartment
• Unscrew and remove the screw on the rear side of the
commeo Multi Send.
• Remove the clip.
• Remove the batteries.
• Insert new batteries (2 x LR03, AAA) in the correct position.
Observe the marking inside the battery compartment.
Battery disposal
Batteries don't belong into the domestic garbage. Please take the batteries used up
to your local gathering point.

9. Maintenance

Clean the device with a damp cloth only. Do not use a cleansing agent since this could
damage the plastic.

10. Technical data

Nominal voltage: 3 V DC
Battery type: 2 x LR 03 (AAA) 1.5 V alkaline batteries
Safety class: IP 20
Permissible ambient temperature: 0 to +55 °C
Radio frequency: 868.1 MHz
Max. transmission output: max. 10 mW
Dimensions: L 169 x W 42 x H 16 mm
Note: The maximum radio range is up to 25 m indoors and up to 350 m in the open field. It is
possible to program up to 32 receivers per channel (PREMIUM) and up to 64 receivers per
transmitter.

11. General declaration of conformity

SELVE GmbH & CO. KG company, hereby declares that the commeo Multi Send is in conformi-
ty with the basic requirements and other relevant provisions of the Directive 2014/53/EU.
The declaration of conformity can be looked up at www.selve.de

12. SELVE Service Hotline

Download the operating manuals
at www.selve.de or QR scan
symbol appears on the display. You can still continue using the
14