Hanging Vac On Storage Rack - RIDGID VAC50000 Mode D'emploi

SP6947 RIDGID 5 Gallon ESF_SP6947 3/11/15 9:49 AM Page 8

Hanging Vac on Storage Rack

1. Set the Vac on the floor near the
storage rack. Measure the distance
from center of storage rack to the
closest electrical outlet and add 18
inches.
2. Uncoil that amount of power cord from
the cord wrap. Drape the loose cord
over the top of the vacuum and down
the front.
3. Grasp the handle with one hand and
the bottom of the Vac canister at the
front with the other hand. Always lift the
Vac with both hands. Lift the Vac up to
the storage rack.
4. Align the upper hook on the Vac with
the rectangular opening in the storage
rack. Push the Vac against the storage
rack.
Rectangular
Opening
Release Tab
Outlet
Distance
+
18 Inches
Handle
Upper
Hook
Lower Hook
Upper
Hook
Push
Vac
Against
Storage
Rack
5. Lower the Vac until the upper hook and
lower hook are engaged and the
bottom of the Vac canister rests on the
rack. The release tab will pop out over
the flange on the motor assembly.
Release
Tab
Upper
Hook
Lower
Hook
6. Snap the power cord into the cord
retainer in the front surface of the rack.
The cord may exit on either the left or
right side. Plug the power cord into the
electrical outlet. Do not fasten power
cord to wall in any way.
8
Storage Rack
Rectangular
Opening in
Storage Rack
Storage
Rack