Troubleshooting - Whirlpool W10115228B Instructions D'installation

10.
Remove door strike
Remove door strike from dryer cabinet and set aside.
11.
Remove and transfer plugs
Remove the 4 screws that attach 2 plugs on the left side.
Transfer plugs to opposite side using the same 4 screws.
12.
Insert screws in hinge holes on
dryer cabinet
NOTE: 2 people maybe needed to reinstall door.
Insert screws into the bottom holes on left side of dryer
cabinet. Tighten screws halfway. Position door so large end of
door hinge slot is over screws. Slide door up so screws are in
bottom of slots. Tighten screws. Insert and tighten top screws
in hinges.
22
13.
Remove door strike plug
Remove door strike plug. Insert the door strike removed in
Step 10 into hole and secure with screw. Insert door strike
plug into original door strike hole and secure with screw.
14.
Check door strike alignment
Close door and check that door strike aligns with door catch.
If it is needed, slide door catch left or right within slot to
adjust alignment.

Troubleshooting

See the "Use and Care Guide" or visit our website and
reference "Frequently Asked Questions" to possibly avoid
the cost of a service call.