Whirlpool W10115228B Instructions D'installation page 21

5.
Flip door over
Flip door over so handle side is down.
6.
Remove screws from door
Remove screws at top, bottom, and side of door (4 screws).
Keep door screws separate from hinge screws as they are
different sizes.
7.
Separate inner from outer door
Holding door over towel on dryer, pry inner door and lift to
separate it from outer door.
NOTE: Do not pull on door seal or plastic door catches.
8.
Rotate outer door
Take outer door and rotate it 180º and set it back down on
inner door. Be certain to keep cardboard spacer centered
between doors. Reattach outer door panel to inner door
panel so handle is on the side where hinges were just
removed. Insert 4 door screws.
9.
Attach door hinges
Reattach door hinges to dryer door so that the larger hole is
at the bottom of the hinge.
21