SOLAC CVG 9800 / C Mode D'emploi page 15

dot will appear alongside the one already there (••), indicating that it is at
temperature level 2. The thermometer will go on the blink again until the
selected temperature is reached. When it has reached it, the warning buzzer
will sound and the thermometer will cease to blink Fig 4. Temperature levels
3 and MAX are selected in the same way.
• From the MAX temperature position, if you press the button again, the iron
will revert to the initial position with 1 temperature dot, and so on. Press
the temperature button for 2 seconds to disconnect the iron. To restart it,
simply press the button again.
Steam selection
• The Compact Vapor Generator has two steam positions; medium steam
(20gr/min) and maximum steam (45gr/min). The medium value always ap-
pears by default when the iron is switched on.
• To obtain maximum steam, simply press the steam selector button once
Fig 2 (i), and the steam icon will appear in the display at its highest flow.
Fig 5. To revert to medium flow, you just have to press the selector button
again. Fig 2 (i).
• When you have chosen the appropriate temperature and steam flow for the
garment, press the steam On-Off switch Fig 6 (g) once and you may start to
iron. It is not necessary to be pushing the steam button continually, just
press once and the steam will issue without interruption. To cut off steam
output, press the steam On-Off switch Fig 2 (g) again and it will cease to
issue automatically.
• ECO-INTELLIGENT: this Solac Compact Ironing System includes a device
for disconnecting the steam function after 3 seconds of not detect-
ing any movement. This ensures lower power consumption as well as
greater autonomy of the tank (lower water consumption).
• The steam function switches back on automatically when the slightest
movement of the Compact Ironing System is detected or when any of
the steam outlet buttons is pressed.
AUTOMATIC SWITCH OFF: AUTO - PAUSE
• The Compact Vapor Generator has an automatic switch-off system. It is
switched off automatically 3 minutes after the last time it was used. This
means that once the device is actuated, the CIS ceases to heat and begins
to cool down. At that moment a buzzer will sound and the icon Fig 2 (f)
will appear on the blink for 5 seconds on the illuminated display, and it
will continue blinking afterwards on the display when it is not lit up Fig 7,
indicating that the appliance has been switched off. To switch it back on,
just move it slightly or else press any of the three control buttons Fig 2 (g,
h, i). The CIS will revert to the temperature and steam position it had before
being switched off.
CVG9800 15
15
9/4/08, 10:03:54