Télécharger Imprimer la page

thuba SAnR Mode D'emploi page 9

Masquer les pouces Voir aussi pour SAnR:

Publicité

Manual Access Point «SAnR/SAtb»
4.
Installation
For installation and operation it is essential
to follow this Manual and the relevant nation-
al regulations in addition to generally accept-
ed good engineering practice and IEC 60079-
14 'Electrical installations design, selection
and erection'.
4.1
Qualifications
The installation of the equipment may only be
carried out by experienced personnel who during
their training have also been instructed in the
various types of explosion protection, installation
processes, the relevant rules and regulations
and the general principles of hazardous zone
classification. Appropriate ongoing training or
instruction must be given to these personnel reg-
ularly.
4.2
Network cable
Only network cables from Huber+Suhner with
the designation Radox Railcat CAT7 100 Ohm,
4x(2x24AWG) XM S can be used.
The minimum cable length of 5 m must not be
undercut. Other cables may only be used after
being approved by the manufacturer.
4.3
Cable and conductor entries
For access points type SAnR/SAtc, only those
cable and conductor entries and plugs that pos-
sess an EU type-examination certificate (accord-
ing ICE Equipment Protection Level Gc or Db)
issued by a European Notified Body as per IEC
60079-0, IEC 60079-7 and IEC 60079-31 may
be used.
Cable and conductor entries may only be fitted
in specially prepared holes that are closed off
with plugs.
The cable and conductor entries must be
installed so as to prevent self-loosening and
ensure permanent sealing of the cable and con-
ductor entry points.
In the factory the cable and conductor entries are
fitted with CEAG type GHG 960 923 P... cable
Edition April 2021
Copyright
Batch-Kabel (Ver-
bindung Anschluss -
modul zum Access
Point
Câble patch (con-
nexion entre le
module de raccor-
dement et l'access
point)
Batch cable (con-
nection of the con-
nection module to
the access point
Ethernet Netz-
werkkabel CAT6
(oder höher)
Câble Ethernet
CAT6 (ou plus)
Ethernet network
cable CAT6 (or
higher)
thuba Ltd., CH-4002 Basel
Switzerland
7

Publicité

loading

Ce manuel est également adapté pour:

Satb