S&P DECOR-100 DESIGN Mode D'emploi page 18

Note:
If the fan never turns on.
- Humidity adjuster is not at its lowest
setting. Turn anticlockwise the ad-
juster (do not force the adjuster) to
the minimum setting.
- The fan is fi tted in an area where
there is no air fl ow.
- The humidity level in the room is be-
low 60% RH
If the fan never stops:
- Humidity adjuster is not at its high-
est setting. Turn clockwise the ad-
juster (do not force the adjuster) to
the maximum setting.
- The humidity level in the room is
above 90% RH
USER INSTRUCTION
This instruction manual is available
under http://www.solerpalau.com or
contact your National Soler & Palau
contact. List in http://www.solerpalau.
com.
CLEANING AND MAINTENANCE
Important: disconnect
mains supply before carrying out
cleaning or maintenance
The Fan needs only a periodical clean-
ing, using a cloth lightly impregnated
with a soft detergent.
18
AFTER SALES SERVICE
We recommend you not to try to dis-
mantle or remove any other parts than
those mentioned as any tampering
would automatically cancel the S&P
guarantee. If you detect any fault, con-
tact your S&P dealer.
PUTTING OUT OF SERVICE AND
RECYCLING
posit all packaging in the appropriate
recycling bins. If your device is also
labeled with this symbol, please take
it to the nearest Waste Management
Plant at the end of its servicable life.
S&P reserves the right to alter specifi -
cations without notice.
from the
EEC legislation and our
consideration of
generations mean
we should always recycle
materials where possible;
please do not forget to de-
future
that