Publicité
Les langues disponibles
Les langues disponibles
B
C
This product can accept any of the batteries
and chargers listed in the chart below.
LI-ION Battery Packs and Chargers
Description
Batteries: LI-ION
Chargers: LI-ION
SAVE THESE INSTRUCTIONS
ASSEMBLY AND ADjUSTMENT
WARNING:
BEFORE ASSEMBLY,
MAkE SURE THAT THE APPLIANCE IS
SWITCHED OFF AND THE BATTERY
HAS BEEN REMOVED.
ASSEMBLY TOOLS REQUIRED (NOT
SUPPLIED):
- Phillips Screwdriver
WARNING:
REMOVE THE BATTERY
BEFORE ATTEMPTING TO ATTACH ANY
OF THE FOLLOWING COMPONENTS.
ATTACHING THE GUARD (FIGURES D
AND E)
WARNING:
NEVER OPERATE
APPLIANCE WITHOUT GUARD FIRMLY IN
PLACE. The guard must always be properly
attached on the appliance to protect the user.
• Remove the screw from the guard.
• Keeping the guard square to the
Cat. #
LBX36
LBXR36
LBXR2036
LBXR2540
LCS36
LCS436
7
trimmer head slide it fully into place
until the retaining tab clicks into place
(Ensure that the guide rails (D1) on the
guard (11) are correctly aligned with the
guide rails (D2) on the trimmer head
(D3) (figure D). The locking tab (D4)
should snapped into the housing slot (D5).
• Secure the guard with the screw (E1)
(figure E).
D
D1
D4
D3
D2
E
ATTACHING THE AUxILIARY HANDLE
(FIGURES F AND G)
• Push the auxiliary handle (F1) onto the
tube (F2).
• Slide the bolt (G1) through the holes in
the auxiliary handle.
• Tighten the knob (G2) onto the bolt by
turning it clockwise.
F
G
G2
ADjUSTING THE POSITION OF THE
AUxILIARY HANDLE (FIG. G)
The auxiliary handle can be adjusted to
provide optimum balance and comfort.
11
D5
E1
F1
F2
G1
Publicité
