Publicité
Les langues disponibles
Les langues disponibles
5. Hints and tips
5.4. Default values
Before Dual Manager has been executed for the first time and presets have been defined by the user, the
amplifier firmware uses default values for the various parameters, as listed in the table below. Please also note
that in the event of a non-volatile memory failure default presets would be restored.
SECTION
Crossover
Q-Bass
Input Section
Output Section
Equalizer
Time Delay
Global
5.5. System and error messages
Hereafter is a list of system and error messages, with their explanations or contexts.
• Loading stages on start-up screen
"Wait hardware."
"Init hardware."
"Create amplifier screen", "Init amplifier screen",
"Read config file","First device automatic selection."
PARAMETER
Slope,dB
Frequency, Hz (High Pass)
Frequency, Hz (Low Pass)
Crossover type
Filter type
Level, dB
Frequency, Hz
Q
Channel
Input Selector
Level,dB
Level,dB
Q
Type
ms
Headroom (dB)
All On/Off buttons
Inverted button
File name
User mode
DEFAULT VALUE
12
500
5000
Band-Pass
Linkwitz-Riley
6
80
1.0
Left/Right
Optical
0
0
2.0
Peak
0
0
Off
Off
No Name
Restricted
Wait idle state in hardware.
Initialize hardware data.
Create visual data.
15
Publicité
