afx light SPARK-FIREWORKS Manuel D'utilisation page 4

ANGLE ADJUSTMENT
Lock Pin
Handle
Hopper Screw
Angle Shaft
The angle of the gun tube can be adjusted by the user between 15° and 60° in 5 steps of 15°. Pull
up the lock pin and adjust the angle. When the shaft is placed in the desired position, release the
lock pin to lock the shaft into position.
INSTALLATION OF BUTANE GAS
The butane gas used in this machine must be approved quality. The cartridges must have the
size of Ø68 x 180mm height with a volume of 220 ±5g.
INSTALLATION OF THE BUTANE GAS CARTRIDGES:
The gas cartridge compartment is located in the right side of the machine. Open the hatch to
access to the 2 compartments for the gas cartridges. Each compartment shows the symbols
and . Remove the cap of the cartridge and align the notch on the top with the UNLOCK sign.
Push the cartridge all the way into the compartment and turn it towards the LOCK sign. If the
cartridge has been properly installed, it can't skip back. Proceed the same way for the second
cartridge. Close the compartment.
To remove the cartridge, turn it to the UNLOCK position and take it out of the compartment. Put
the cap back on the cartridge to avoid any gas leakage during storage.
FILLING IN THE GRANULATE
Please use our MEDIUM size granulate for spark fountains of 2-3m height (order code:
SPARK-POWDER-MEDIUM).
1. Loose the hopper screw on the nozzle and remove the hopper.
2. Turn the hopper upside down and unscrew the cap.
3. Fill in the granulate as shown in the illustration below.
4. Close the hopper, turn it upside down and place it on the nozzle. Secure the hopper with the
screw.
EN 4 © Copyright LOTRONIC 2022