mspa ELITE BAIKAL Manuel Du Propriétaire page 15

6. Water Filling
6.1 Check the spa mark is at the selected area and point
the drain valve toward a suitable draining area
before inflation.
6.2 Fill the spa tub with fresh water to a level between
Minimum and Maximum line marked on the inside
of the spa wall. Do not over fill the spa. It is recommended to fill the spa with lukewarm water for quick
heating and energy saving.
WARNING:
The water level must reach the Minimum water line but not exceed the Maximum line to avoid
pump failure.
Never pour water with a temperature higher than 40°C (104°F) directly into the spa.
To avoid control system failure, do not operate the spa until water reaches the Minimum
line.
6.3 After water filling, double check the spa pool air pressure to make sure the manometer points out the
6.4 Place the inflated air bladder and the zipper spa cover over the spa tub. Make sure the spa cover is
zipped and locked by the digital lock in the accessory pack.
IMPORTANT:
6.4
6.5 Turn on the Heater on the spa wired controller, refer to the "Wired Controller Operation" section.
7. Zipper and Buckle Operation
7.1 Digital Lock Operation
The default password is "000"
6
15