mspa ELITE BAIKAL Manuel Du Propriétaire page 14

Note:
Before inflation, check whether the manometer cap is screwed up tight on the valve of pool
body. If not, please tighten and then inflate. After inflation, the manometer cannot be removed,
otherwise the air will be released.
When the Yellow section is pushed out, the Spa inflation is completed. You can fill the Spa with water.
After water filling is completed, check the air pressure once again to ensure the manometer reaches its
Green section. Always ensure the manometer is in the Green section during use.
If the White section of the manometer appears, the spa is over inflated. Rotate the valve cap counter
clockwise, have the air released till the Green section is pushed out, then tighten it clockwise.
To avoid over inflation caused by warm weather or sunshine when leaving spa for weeks inflated and
manometer is always on in the Yellow section.
5. Spa Bladder Inflation.
5.1 Open the air valve (a) on the bladder. Insert the inflation
hose (b) into the valve. Open the air valve (C) on the spa
pool. Make sure you choose the correct one in black color.
5.2 Press the Bubble
is firm to touch but not hard.
5.3 Press Bubble
turn off the function. Disconnect the inflation hose from the
air blower outlet and the valve.
5.4 Replace the air valve cap (c) back. Close and recess the
inflation valve (a).
NOTE: Deflation Instruction
Spa Deflation
1. Unscrew the air valve cap on the spa pool to deflate the spa.
2. Once the deflation is completed, place the cap back.
Spa Bladder Deflation
1. Pull the valve cap out and squeeze the valve at its base until deflated.
2. Close and recess the valve back.
button to inflate until the bladder
BUBBLE
button for more than 3 seconds to
BUBBLE
5
14
Yellow
Green
White
(c)
(b)
(a)