Multimetrix CM600 Notice De Fonctionnement page 11

6.1 THE FRONT FACE
No. Function
1. Black negative COM terminal (-)
2. Liquid crystal display:
- CM600 / CM610: 3 ½ digits (1999 points)
- CM625: 4 digits (4369 points)
'----': current and voltage measurements exceed the
range
3. Function rotary selector switch
OFF : Multimeter off
4. Trigger for opening the clamp
5. When measuring, your hand must always be behind this
protective guard.
7. For maximum accuracy, the conductor must be located in
the centre of this area during measurement.
8. MAX button (CM600 and CM610): this shows the
maximum value, automatically updated, for the
when the function is activated: pressing it again cancels
the function.
9. SELECT button.
CM600 and CM610: Alternately selects diode test
continuity test
CM625: Alternately selects measurement of:
- the DC current or reset (40 ADC range);
- the resistance or continuity test
10. Red positive terminal (+).
11. CM625: indicates the clamp's orientation.
12. HOLD button (CM625)
This holds the measurement (Data Hold); the
appears when the function is activated. Pressing the
button again cancels the function. Automatic shutdown
AUTO POWER OFF (25) is deactivated in this mode.
6.2 THE DISPLAY
No. Function
13. Continuity
14. Negative value
15. AC
16. DC
17. Low batteries
18. Max. value
19. Diode test
6.3 THE REAR FACE
No. Function
27. Safety text
6. INTRODUCTION
: AC current (CM600 and CM610: 600 A and
CM625: 400 A)
: DC current
(only on CM625: 400 A)
: AC voltage on CM600, CM610
and CM625 (600 V)
: DC voltage on CM600, CM610 and CM625
(600 V)
: Resistance (only on CM600 and CM610: 20 MΩ)
: Resistance and continuity
(only on CM625: 40 MΩ)
: Diode and continuity test
(only on CM600 and CM610)
functions. The
.
USE
No.
20.
21.
22.
23.
24.
25.
No.
28.
11
icon is displayed
.
Function
Resistance
Current voltage
Max. value
Auto ranges
Hold value
Auto shutdown
CM625 only
Function
Battery compartment
or
icon