Multimetrix CM600 Notice De Fonctionnement page 10

1.5 OTHER SAFETY RECOMMENDATIONS
For instruments of installation categories I and II, never work on
equipment that could generate voltage spikes (motors, etc.).
When measuring in the manual range, always start with the
maximum range and then select the most appropriate range.
First of all connect the black contact point and then the red one.
Disconnect the power cables before changing function.
First of all disconnect the red contact point and then the black one.
Use and install batteries that comply with the instructions in the
user's manual for the product you have purchased.
Check that there is no voltage present before using the
Ω functions.
The instrument is guaranteed against any material or manufacturing
fault in accordance with the General Sales Conditions. During the
guarantee period, the instrument may only be repaired by the
manufacturer, who reserves the right either to proceed to repair the
product or replace it in whole or in part. If any equipment is returned
to the manufacturer, the customer is responsible for paying the
outward transport costs. The guarantee does not apply in the case of:
Improper use of the instrument or its use with incompatible
equipment.
Modification of the instrument without express authorisation
from the manufacturer's technical departments.
Any work being performed on the instrument by anyone not
formally approved by the manufacturer.
Any adaptation for any particular application not provided for in
the instrument's definition or the operating instructions.
An impact, a fall or drenching in water.
Information and contact details for our After-Sales Services :
contact your distributor.
3. UNPACKING AND REPACKING
All the equipment has been checked mechanically and electrically
before dispatch.
However, you are advised quickly to check for any damage during
transport. Should this be the case, inform the freight forwarder
immediately of your reservations.
If you are sending anything back, please use the original packaging
and attach a note indicating the reason for the return.
4.1 METROLOGICAL CHECKS
As with any measuring or testing instrument, periodic checking is
required. Information and contact details are available on request or
contact your distributor.
4.2 SERVICING
Periodically clean your multimeter with a cloth dampened with soapy
water. Do not use abrasives or solvents.
4.3 REPAIRS OUTSIDE METROPOLITAN FRANCE.
For any work under or outside the guarantee, the instrument must be
returned to the distributor.
Remove the batteries and store them separately if you measuring
instrument has not been used for more than 60 days.
2. GUARANTEE
4. MAINTENANCE
5. STORAGE
10
and