Télécharger Imprimer la page

Thetford Spinflo S OH70000Y Serie Mode D'emploi Et Notice D'installation page 21

Publicité

Les langues disponibles

Les langues disponibles

MAINTENANCE & SERVICING
Service Instructions
6. Spark Ignition (where fitted)
Disconnect from gas supply (1). Remove appliance from housing (2).
Grill burner – At rear of appliance remove the screw from the brack
ignition probe. Trace the
connector.
Oven burner - Trace the electrode wire up the back of the cooker to the generator
and pull off the connector. Unscrew the fixing screw on the spark electrode inside
the oven cavity, then carefully pull the electrode from inside the oven and remove
Piezo Spark Generator replacement - Remove all electrode wires. Remove the
lock nut and carefully remove from panel.
12v Spark Generator replacement - Located at the rear of appliance. Remove al
electrode wires, unscrew the two retaining screws and lift off the unit.
7.
Hob burner injector (No81, No67, No62, No53) – see Fig. 11
Lift off the panrest and remove the two screws retaining the burner spreader. Lift off
the burner spreader to gain access to the injector. A box spanner or m
socket should be used to unscrew the injector from the burner cup.
8.
Grill burner injector (No62) – see Fig. 11
Disconnect from gas supply (1). Remove appliance from housing (2).
Release the locking screw on the injector holder, disengage the grill pipe from the
control and remove the injector.
9.
Oven burner injector (No65) – see Fig. 11
Open the oven door and unscrew the burner retaining screw, sl
left and lift out. The injec
Unscrew the in
10.
Thermocouple replacement
Disconnect from gas supply (1). Remove appliance from housing (2).
Grill burner - Unscrew the thermocouple from the control. Unscrew the nut at th
burner.
Oven burner - Unscrew the thermocouple from the control. Inside the oven cavity,
the thermocouple is found just above the burner on the rear wall. Unscrew the
locknut and pull ou
11.
Removing Drop Down O
Open the door and engage catch to hook on each hinge. Lift the door and pull ou
front trim.
electrode wire back to the generator and pull off the
tor is exposed to the right hand side of the cut out.
jector.
t the thermocouple from the rear of the appliance.
ven Door
21
et and spark
.
iniature
ide the burner to the
e
t of
l

Publicité

loading

Ce manuel est également adapté pour:

Spinflo s oh71000y serieTriplexTriplex dual fuel