Publicité
Les langues disponibles
Les langues disponibles
MAINTENANCE & SERVICING
Service Instructions
1
.
D
isconnect from gas supply
Lift and remove the bottom plinth to gain access, then disconnect the ga
If
the appliance is Dual Fuel, disconnect/isolate the electric supply.
2.
R
emove hob surface
Disconnect from gas supply (1) and electric supply if Dual Fuel. Lift off the Panrest
and remove the two screws securing each burner spreader. Remove front fascia by
removing all push on control knobs and unscrew the two recessed fixed nuts a
both
fascia retaining screws. Carefully lift off the fascia and if spark ignition fitted
remove the two spade connectors from the rear of the toggle switch. Remove the
two central screws securing the pressing to the rear box section. Rem
front retaining screws located each side and access
the angled front. Grasp the hob by the angled front face, carefully lift the hob
surface from
Note:- On Dual Fuel appliances, remove the hotplate rear cover and disconnect th
power leads. The hob surface should b
3. Remove appliance from housing
Disconnect from gas supply (1). Ope
each side trim - note the appliance can either be front or side fixed, see under
Fixing, page 17. Open the glass lid and remove the 2 screws from each side trim.
Carefully slide the appliance out one third and check for any possible snagging of
wires or pipes. If the appliance is Dual Fuel, disconnect su
terminal block. If OK, lift applia
4. Co
ntrol replacement
Ho
b controls
Disconnect from gas supply (1). R
cor
responding pipe and thermocouple and remove from the control.
Op
en the oven door and unscrew the 2 screws holding the thermostat probe in
position and push the probe back out through the hole in the
the
retaining screws from on top and underneath the control. Disconnect the inlet
pip
e and two burner supply pipes. Remove the fittings off the old control and f
the
replacement.
Ov
en and Grill control
As above instructions but remove appliance from housing to gain access to the
oven thermostat, grill and oven thermocouples.
Remove the grill burner
5.
Disconnect from gas supply (1). Remove applian
surface (2). Remove the two screws retaining the heat deflector. Remove the
insulation wrap and lever off the two starlock washers retaining the grill burner. Lift
out the burner assembly.
the front to allow the rear edge to unhook from the rear box section.
nce out onto a suitable surface.
ed through the outer slots on
e put onto a suitable surface.
n the oven door and remove the 2 screws from
emove hob surface (2). Unscrew the
ce from housing (3). Remove hob
20
s supply.
ove the two
pply lead from rear
rear of oven. Remove
nd
e
it on
Publicité
