Publicité
Les langues disponibles
Les langues disponibles
INSTALLATION
Dual Fuel Appliances - Electrical Connection
This appliance must be connected using a double insulated cord, type 227 IEC 53,
HO5V V-F, which is suitable for use up to 4 amps. See Fig 4 for terminal connection
d
etails. This should be connected to a double pole switched mains supply, with 3mm
minimum contact separation at all poles. The supply cord must be retained using the
attached cable clamp and routed to the side through the supplied 'P' clip. Excess cord
m s
u t be routed away from the appliance and must not come into contact with the ove
body
or hang loose into the lower compartment.
All Mod
els
The a p
p
liance must be electrically grounded in accorda
the a
bs nce of such codes, with the National Electrical Code, ANSI / NFPA 70.
e
Models
with 12Volt Spark Ignition
Conn c
e tion to the 12volt electrical supply of the recreational vehicle is made via the spade
terminals located on the spark ignition generator. A supply cord terminating in sheathed
spade connectors is recommended. The supply cord should be retained against the rear
appliance s
upport leg using a 'P' clip and routed away from the appliance.
All Models – Pressure Testing
The appliance and its individual shutoff valve must be disconnected from the gas sup
piping system during any pressure testing of the system
½ psi (3.5kPa).
The appliance must b
manual shutoff
v
alve during any pressure testing of
p
ressures equa
l
to or less the ½ psi (3.5kPa).
When satisfied with the appliance and after instructing the user on the correct
method of operation, these instructions MUST be left with the appliance. If th
appliance fails to operate correctly after all checks have been made, refer to the
a
uthorised
service provider in your area.
IMPORTANT
• After installation the appliance MUST be tested for soundness
• Test ALL burners on high and low flame for flame stability.
•
The gas supply input pressure MUST NOT rise or fall significantly from
nominal when ALL appliances connected to the supply are operated
simultaneously. If NOT installed to the manufacturers instructions detailed
herein, we the manufacturer can not be held responsible for any problems
that occur, or poor performance that is perc
e isolated from the gas supply system be closing its individual
nce with state or other codes or,
at test pressures in excess of
the
gas supply piping system at test
eived/witnessed.
18
n
in
ply
e
Publicité
