Publicité
Les langues disponibles
Les langues disponibles
Fig. 7
3. Extend the pole to the desired length (Fig. 8).
NOTE: Push poles toward each other to shorten the pole
or pull them away from each other to lengthen the pole.
Only extend the pole to the minimum length required to
reach the hedges to be trimmed.
Fig. 8
Telescoping pole
4. Lock the pole in position by closing the cam-lock (Fig. 9),
and ensure that the pole is secure. If the pole telescopes
when the cam-lock is closed, the nut may need tightening.
Fig. 9
Cam-lock
m
WARNING!
Extend the telescoping pole only to the
length required to reach the hedges being trimmed. Adjust
your hand placement on the telescoping pole of the pole
hedge trimmer in order to keep proper balance.
Do not attempt to use the pole hedge trimmer at a length
which does not allow you to achieve proper footing and
balance at all times!
Cam-lock
m
as directed could result in personal injury.
Tightening the Bolt
The retaining bolt may need tightening to secure the telescopic
pole in place.
1. Unclip the cam-lock. Using the hex key wrench, tighten
Adjusting Pivoting Head
The pole hedge trimmer head can be rotated into 6 different
cutting angles.
1. Always disconnect the pole hedge trimmer from the power
2. Place the pole hedge trimmer on a sturdy flat surface.
3. Press the pivot button and adjust the trimmer head to the
10
WARNING!
Failure to lock the telescopic pole cam-lock
the cam-lock nut, then close the cam-lock. Ensure that the
pole is secure. The wrench may be required to loosen the
cam-lock nut if you need to adjust the pole to a different
height (Fig. 10).
Fig. 10
Cam-lock nut
supply.
desired angle (Fig. 11).
60º
Fig. 11
30º
0º
-30º
-60º
Hex key wrench
Pivot button
-90º
Publicité
