Publicité
Les langues disponibles
Les langues disponibles
Agitator Roll
Disconnect cleaner from electrical outlet before checking or replacing agitator roll.
Agitator Roll Sleeve
When to Replace
To check condition of brushes, move edge of a card across agitator opening. Rotate agitator by hand. If
brushes do not touch edge of card, the brushes are worn and brush roll should be replaced.
How to Replace
Remove bottom plate and pull out agitator. Slip V-belt off of agitator. (Figs. 2.4-2.8)
2.9
A
If agitator does not rotate, the V-belt is not positioned properly in the groove of the idler pulley.
Should this occur, proceed as follows:
1. Disconnect cleaner from electrical outlet.
2. Referring to section "How to replace belts", remove hood and reposition V-belt into groove of idler pulley.
3. Reposition hood, turn cleaner over and replace hood screws. Tighten screws with screwdriver.
Agitator Roll Sleeve: What to Buy
Use only genuine Hoover ® Commercial agitator roll sleeves with your cleaner. For the Conquest 14, ask for Hoover ®
Commercial part No. 48416035. For the Conquest 18, ask for Hoover ® Commercial part No. 48416036.
Pull V-belt up through opening in cleaner. Position belt into
groove in new agitator roll sleeve.
Reposition agitator by sliding square and round projections on
agitator ends into square and round slots on sides of nozzle.
Roll agitator toward rear of cleaner.
Reposition bottom plate. Replace bottom plate screws.
Tighten screws with screwdriver.
To make sure agitator rotates, plug cleaner into electrical
outlet and turn cleaner on.
8
Publicité
