T40PLUS - T40WPLUS
Residual Risks
After carefully considering the risks that are present in all
machine operating phases, necessary measures were adopted
in order to eliminate the risks for the operators, as far as
possible, and/or limit or reduce the risks deriving from hazards
that cannot be completely eliminated at the source.
During
operations
exposed to certain residual risks which, due to the nature of
the operations themselves, cannot be completely eliminated.
Therefore the installer is responsible for providing additional
information and/or hazard signals based on the location of
machine installation and the material that is handled.
■
Risks due to electrical hazards during maintenance
Risk of electrocution if accessing the electrical
equipment
during
deactivated the electrical power supply.
It is forbidden to work on the electric equipment
before disconnecting the machine or its parts from the
electrical line.
Have the electrical maintenance operations performed
by qualified personnel. Perform the checks on the
electric equipment as specified in the manual.
■
Risks to the presence of residual high temperature
after stopping the vacuum unit.
During maintenance and cleaning operations, the operator
may come into contact while the machine is stopped, with
parts of the vacuum unit with surfaces at high temperatures.
Specific warning signs placed in strategic points indicate the
hazard due to the presence of hot surfaces and the obligation
for the user to wear personal protective equipment, in particular
protective gloves.
The potentially hot parts (high temperatures) are identified as
follows:
GB
EC Declaration of conformity
Every machine comes with a EC Declaration of conformity. See
fac-simile in fig. 31.
The Declaration of conformity is an important document
and should be kept in a safe place to be presented to the
Authorities on request.
C380
and/or
maintenance,
operators
DANGER
maintenance
without
FORBIDDEN
MANDATORY
IT IS MANDATORY
TO WEAR GLOVES
CAUTION
DANGEROUS
TEMPERATURES
[ NOTE ]
are
having
4