Horizon Fitness PARAGON X Guide De Montage page 6

READING RACK
CONSOLE
WATER BOTTLE HOLDER
ON/OFF SWITCH
POWER CORD
CONSOLE MAST
CAUTION WARNUNG
KEEP HANDS AND FEET AWAY HALTEN SIE HÄNDE UND FÜSSE
FROM THE MOVING PARTS. VON BEWEGLICHEN TEILEN FERN.
1
2
FOOT LOCK LATCH (UNDERNEATH DECK)
10
HZ19_AG_Paragon X v1_0_A.indd 10-11
TOOLS INCLUDED:
5 mm L-Wrench
6 mm T-Wrench
Phillips Screwdriver
SPEED INSTANT KEY
HAND PULSE SENSOR
HANDLEBARS
PARTS INCLUDED:
2 Console Masts
ACCESSORY TRAY
1 Console Assembly
SAFETY KEY PLACEMENT
2 Handlebars
1 Hardware Kit
MOTOR COVER
1 Safety Key
1 Power Cord
FOR CENTERING THE BELT
1 Bottle of Silicone Lubricant
1 Pad Holder Cover
1 Pad Holder
SIDE RAIL
NEED HELP?
RUNNING BELT/DECK
If you have questions or if there
are any missing parts, contact
REAR ROLLER
TENSION/ADJUSTMENT BOLTS
Customer Tech Support.
TRANSPORT WHEEL
PRE ASSEMBLY
UNPACKING
Place the treadmill carton on a level flat surface. It is recommended that you place
a protective covering on your floor. Take CAUTION when handling and transporting
this unit. Never open box when it is on its side. Once the banding straps have been
removed, do not lift or transport this unit unless it is fully assembled and in the upright
folded position, with the lock latch secure. Unpack and assemble the unit where it
will be used. The enclosed treadmill is equipped with high-pressure shocks and may
spring open if mishandled. Never grab hold of any portion of the incline frame and
attempt to lift or move the treadmill.
WARNING
• DO NOT ATTEMPT TO LIFT THE TREADMILL! Do not move or lift treadmill
from packaging until specified to do so in the assembly instructions. You may
remove the plastic wrap from console masts.
• FAILURE TO FOLLOW THESE INSTRUCTIONS COULD RESULT IN INJURY!
IMPORTANT NOTES
• During each assembly step, ensure that ALL nuts and bolts are in place and
partially threaded. It is recommended you complete the full assembly of your
unit before completely tightening any ONE bolt.
• Several parts have been pre-lubricated to aid in assembly and usage. Please
do not wipe this off. If you have difficulty, a light application of lithium bike grease
is recommended.
• Removal of fixed guards should be done ONLY by a qualified service technician.
Ensure all fasteners are properly reinstalled after replacing fixed guards.
11
6/18/19 1:54 PM