JumpTek 184-0770 Guide D'assemblage, D'utilisation Et D'entretien page 9

ASSEMBLY
When connecting the Springs (11), always connect the Springs opposite to each other to get an even result in
•
tensioning the Trampoline Mat (10).
Notes:
The even distribution of tension is a critical factor in the proper assembly of the Trampoline Mat.
•
If the Springs (11) can only be inserted with the use of extensive force, they are not
•
inserted in the correct order and manner.
Make sure that the Springs (11) are always inserted at an angle of approximately 90° to
•
the openings on the Top Rail Frame.
After completing the assembly, the Trampoline Frame and Mat should look like the illustration below.
•
Step 7: Assembling the Supporting Poles
Connect all six Upper Supporting Poles (17) to the six Lower Supporting Poles (9). Make sure that the
•
locking tabs "click" into the openings of the Upper Supporting Poles (17).
Note: All of the Supporting Poles come with pre-installed Pole Foams (15, 18).
9