HIKOKI CR 12DA Mode D'emploi page 9

2. If liquid leaks onto your skin or clothes, wash well with
clean water such as tap water immediately.
There is a possibility that this can cause skin irritation.
3. If you fi nd rust, foul odor, overheating, discolor,
deformation, and/or other irregularities when using the
battery for the fi rst time, do not use and return it to your
supplier or vendor.
WARNING
If a conductive foreign matter enters in the terminal of lithium
ion battery, the battery may be shorted, causing fi re. When
storing the lithium ion battery, obey surely the rules of
following contents.
○ Do not place conductive debris, nail and wires such as
iron wire and copper wire in the storage case.
○ To prevent shorting from occurring, load the battery in
the tool or insert securely the battery cover for storing
until the ventilator is not seen.
REGARDING LITHIUM-ION BATTERY
TRANSPORTATION
When transporting a lithium-ion battery, please observe the
following precautions.
WARNING
Notify the transporting company that a package contains a
lithium-ion battery, inform the company of its power output
and follow the instructions of the transportation company
when arranging transport.
○ Lithium-ion batteries that exceed a power output of 100 Wh
are considered to be in the freight classifi cation of
Dangerous Goods and will require special application
procedures.
○ For transportation abroad, you must comply with
international law and the rules and regulations of the
destination country.
Power Output
2 to 3 digit number
NAMES OF PARTS (Fig. 1–Fig. 13)
Handle
Lock-off button
Motor
Housing
Name plate
LED light
Blade holder
Blade
Base
Base lock button
Trigger switch
Battery
00Book̲CR12DA.indb 9 00Book̲CR12DA.indb 9
SYMBOLS
WARNING
The following show symbols used for the machine. Be
sure that you understand their meaning before use.
Battery
Blade hole
Latch
Pilot lamp
Display panel
Remaining battery
indicator switch
Remaining battery
indicator lamp
Jigsaw blade
Slit of plunger
Cavity
Another blade
Stroke
Collar
NOTE
To prevent the battery power consumption caused by
forgetting to turn off the LED light, the light goes off
automatically in about 3 seconds.
9
CR12DA: Cordless Reciprocating Saw
To reduce the risk of injury, user must read
instruction manual.
Only for EU countries
Do not dispose of electric tools together with
household waste material!
In observance of European Directive 2012/19/EU
on waste electrical and electronic equipment and
its implementation in accordance with national
law, electric tools that have reached the end of
their life must be collected separately and returned
to an environmentally compatible recycling facility.
Direct current
Switching ON
Switching OFF
Disconnect the battery
Lock
Unlock
Warning
Prohibited action
Remaining battery indicator switch
Lights ;
The battery remaining power is over 75%
Lights ;
The battery remaining power is 50%–75%.
Lights ;
The battery remaining power is 25%–50%.
Lights ;
The battery remaining power is less than 25%
Blinks ;
The battery remaining power is nearly empty.
Recharge the battery soonest possible.
Blinks ;
Output suspended due to high temperature.
Remove the battery from the tool and allow it to
fully cool down.
Blinks ;
Output suspended due to failure or malfunction.
The problem may be the battery so please
contact your dealer.
English
2021/02/02 17:14:18 2021/02/02 17:14:18