Télécharger Imprimer la page

HIKOKI CR 12DA Mode D'emploi page 10

Masquer les pouces Voir aussi pour CR 12DA:

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 23
English
STANDARD ACCESSORIES
In addition to the main unit (1 unit), the package contains the
accessories listed on page 186.
Standard accessories are subject to change without notice.
APPLICATIONS
○ Cutting metal and stainless steel pipe.
○ Cutting various lumber.
○ Cutting mild steel, aluminum and copper plate.
○ Cutting synthetic resins, such as phenol resin and vinyl
chloride.
SPECIFICATIONS
Model
Voltage
No-Load Speed
Stroke
Mild Steel Pipe
Vinyl Choride
Pipe
Capacity
Mild Steel Plate
Wood
Weight*
*
According to EPTA-Procedure 01/2014
Depending on attached battery. The heaviest weight is
measured with BSL1240M (sold separately).
NOTE
Due to HiKOKI's continuing program of research and
development, the specifi cations herein are subject to
change without prior notice.
Before charging
While charging
Charging
Pilot lamp
complete
(red)
Overheat
standby
Charging
impossible
00Book̲CR12DA.indb 10
00Book̲CR12DA.indb 10
CHARGING
Before using the power tool, charge the battery as follows.
1. Connect the charger's power cord to the receptacle.
2. Insert the battery into the charger.
3. Charging
● Pilot lamp indication
CR12DA
12 V
0–3200 min
–1
13 mm
O.D. 50 mm
O.D. 50 mm
12 mm
50 mm
1.4–1.5 kg
Table 1
Indications of the pilot lamp
Lights for 0.5 seconds. Does not light for
Blinks
0.5 seconds. (off for 0.5 seconds)
Lights continuously
Lights
Lights for 0.5 seconds. Does not light for
Blinks
0.5 seconds. (off for 0.5 seconds)
Lights for 1 second. Does not light for
Blinks
0.5 seconds. (off for 0.5 seconds)
Lights for 0.1 seconds. Does not light for
Flickers
0.1 seconds. (off for 0.1 seconds)
10
When connecting the plug of the charger to a receptacle,
the pilot lamp will blink in red (At 1- second intervals).
Firmly insert the battery into the charger as shown in
Fig. 3 (on page 2).
When inserting a battery in the charger, charging will
commence and the pilot lamp will light continuously in
red.
When the battery becomes fully recharged, the pilot lamp
will blink in red. (At 1-second intervals) (See Table 1)
The indications of the pilot lamp will be as shown in
Table 1, according to the condition of the charger or the
rechargeable battery.
Battery overheated. Unable
to charge. (Charging will
commence when battery cools)
Malfunction in the battery or
the charger
2021/02/02 17:14:18
2021/02/02 17:14:18

Publicité

loading