Valor PORTRAIT 531CSB Manuel D'installation Et D'utilisation page 4

Installation
Ensure that the venting and gas fi tting are completed
and that the ceramics and window are installed before
assembling casting.
1. Attach the stand-off spacers.
They need not be fi tted if the
rear of the appliance is more
than 1-1/4" (32 mm) from
any combustible material.
2. Install the top baffl e using 2
screws supplied.
3. Bolt the left and right side castings in place using
the bolts and washers supplied. Leave the bolts
slightly loose to allow the side castings to move as
necessary when the front casting is hooked on.
4. Hang the front casting by the hooks at the 4 corners.
4
5. Fit the top casting making sure that the corners
locate as shown.
Note: The rear edge of the top casting should be
fl ush with the rear edge of the side castings.
6. Fit the top infi ll casting (if rear vent connection).
7. If necessary, the appliance can be leveled by the
adjustment bolts at the back of the side castings.
Side casting
inside
face
Rear levelling bolt
8. Install the barrier screen. Rest the screen on the
lower edge of the casting and push it in fi rmly so the
spring clips holds it tight against the casting.