Philips AVENT SCD843/37 Mode D'emploi page 10

10
English
1
Eco 20°C
Using the baby monitor
Linking parent unit and baby unit
- When the rechargeable battery of the parent unit is almost empty, the
battery status light turns red and the parent unit beeps.
- If the battery is completely empty and the parent unit it not connected to
the mains, the parent unit automatically switches off and loses contact
with the baby unit.
Note: The built in rechargeable battery cannot be removed from the
product.
Note: The battery gradually and very slowly discharges, even when the
parent unit is switched off.
Tip: To save battery, switch off the parent unit when you do not use it.
Note: We advise you to keep the parent unit connected to the mains during
the whole night. If the battery of the parent unit runs low during the night,
the parent unit beeps and this may wake you up.
1 Push the on/off slide on the baby unit upwards to the ON position.
2 When the baby unit is on, the power-on light on the baby unit lights up
green.
Note: The power-on light on the baby unit always lights up green, even
when there is no connection with the parent unit.
3 Make sure that the parent unit and the baby unit are at least 2.5 meters/
8.2 feet away from each other to avoid acoustic feedback.