RS Pro 124-4134 Manuel D'utilisation page 8

3. Heat the lead frame evenly (Fig. 7)
4. Cleaning
When soldering is completed, clean the residual flux from the board
with an appropriate cleaner.
V. Soldering iron operation instructions
1. Soldering iron stand assembly
● Install the cleaning sponge into the seat. (Fig. 8)
***ATTENTION***
Sponge will swell when wet. Dampen the sponge with water and
squeeze dry before using. The tips may be damaged when used
with dry sponge.
2. Insert soldering iron into the stand.
3. Take out the protection tube on the top of soldering iron.
4. Connect soldering iron cable to the 5 hole socket on the control station
***ATTENTION***
Switch off the power before inserting or pulling out the plug
Fig. 8
Fig. 7
EN-7